Product code: FP8; FP10
Contact Konsa for pricing and availability. Specifications are confirmed during enquiry.
Konsa form pads provide a broad bearing surface for formwork tie and support assemblies, helping spread concentrated loads over the shutter or backing structure. Standard pads measure 150 × 150 mm and are available in 8 mm and 10 mm thicknesses. Use the pad size and thickness specified by the formwork design, together with compatible hardware and appropriate installation procedures.
Related products: Tie-Rod Washers, Tie-Rod Nuts, Waler Clips, and the Formwork Products and Accessories category.
Need help choosing form-pad thickness for your shutter loads? Our team can advise on pad size for your formwork design.
| Product Code | Size (mm) | Thickness (mm) | Mass (kg) |
|---|---|---|---|
| FP8 | 150x150 | 8 | 1.45kg |
| FP10 | 150x150 | 10 | 1.65kg |
Sizes and codes extracted from the legacy product table.
Code: F20
Konsa reusable plastic fillet corners create clean chamfered edges on concrete slabs, columns, beams and precast components. They can be fixed to timber formwork with nails or screws, or attached to steel shutters using a suitable contact adhesive. Standard profiles are supplied in 3 m lengths, with dimensions listed in the specification table for selecting the required chamfer size.
Code: FN20
Konsa reusable plastic fillet corners with fixing lips create consistent chamfers while simplifying attachment to timber or steel formwork. Narrow-lip profiles can be wedged or nailed at the shutter edge, wide-lip profiles allow fixing away from the edge, and slotted versions are available for metric, imperial and P.M.I. shutter systems. Profiles are supplied in 3 m lengths; select the size and slot pattern from the specification tables.
Code: PS14
Konsa plastic ferrule tube spaces opposing formwork panels while creating a sleeve around through-tie rods, allowing the tie rod to be withdrawn and reused after casting. The range covers several internal and external diameters to suit different tie systems. Tubes can be supplied in 3 m lengths for cutting on site or cut to the length required for the formwork assembly.
Code: PC14
Konsa push-on plastic cones fit onto the ends of compatible ferrule tubes in formwork tie systems. After the shutters are removed, the cones can be extracted to leave a neat chamfered recess around the tie opening for subsequent grouting or finishing. Multiple sizes are available; match the cone product code to the ferrule-tube diameter shown in the specification table.