Product code: STT50
Contact Konsa for pricing and availability. Specifications are confirmed during enquiry.
Konsa shutter tape is a 150-micron yellow PVC tape used to seal joints and small gaps in concrete formwork. By closing potential leakage paths before the pour, it helps reduce grout loss and improve the finish along shutter joints. The tape is supplied in 50 mm × 30 m rolls. Apply it to clean, dry surfaces and confirm adhesion before concrete placement.
Related products: Shutterseal / Groutex, Plastic Fillet Corners, Shutter Release Oil, and the Formwork Products and Accessories category.
Need guidance on sealing shutter joints before the pour? Our team can advise on tape use alongside foam seals and release oil.
| Product Code | Width (mm) | Roll Length (m) |
|---|---|---|
| STT50 | 50 | 30 |
Sizes and codes extracted from the legacy product table.
Code: F20
Konsa reusable plastic fillet corners create clean chamfered edges on concrete slabs, columns, beams and precast components. They can be fixed to timber formwork with nails or screws, or attached to steel shutters using a suitable contact adhesive. Standard profiles are supplied in 3 m lengths, with dimensions listed in the specification table for selecting the required chamfer size.
Code: FN20
Konsa reusable plastic fillet corners with fixing lips create consistent chamfers while simplifying attachment to timber or steel formwork. Narrow-lip profiles can be wedged or nailed at the shutter edge, wide-lip profiles allow fixing away from the edge, and slotted versions are available for metric, imperial and P.M.I. shutter systems. Profiles are supplied in 3 m lengths; select the size and slot pattern from the specification tables.
Code: PS14
Konsa plastic ferrule tube spaces opposing formwork panels while creating a sleeve around through-tie rods, allowing the tie rod to be withdrawn and reused after casting. The range covers several internal and external diameters to suit different tie systems. Tubes can be supplied in 3 m lengths for cutting on site or cut to the length required for the formwork assembly.
Code: PC14
Konsa push-on plastic cones fit onto the ends of compatible ferrule tubes in formwork tie systems. After the shutters are removed, the cones can be extracted to leave a neat chamfered recess around the tie opening for subsequent grouting or finishing. Multiple sizes are available; match the cone product code to the ferrule-tube diameter shown in the specification table.